Buehler镶嵌机SimpliMet 3000型产品特点：
可编程性降低复杂性
· 适用于有多种镶嵌样需求且镶嵌尺寸不同的实验室。
· 存储和撤销5种不同的程序，降低复杂性和消除错误， 提供灵活性来满足多变的实验室要求
通过选择不同尺寸的模具来优化各种各样的试样大小。节约镶嵌介质并提升镶嵌质量
|
Specifications |
|
|
Operation |
Automatic electro-hydraulic |
|
Power Source |
85-264VAC, 50/60Hz, 1 phase |
|
Molding Pressure |
1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments |
|
Molding Temperature |
120 - 360°F [50 - 80°C] in 20°F [10°C] increments |
|
Heating Power |
1500Watt @ 115/230VAC |
|
Heating Time |
0 - 20 minutes in 10 second increments |
|
Cooling Time |
0 - 30 minutes in 10 second increments |
|
Mold Type |
Cylindrical, including upper and lower rams and duplex mold spacer |
|
Closure Type |
Insluated bayonet with piston indent |
|
Mold Diameters |
1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm |
|
Touch-pad Controls |
On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods |
|
Units of Measure |
Imperial or Metric |
|
Water Flow Rate |
0.5gal/min [2ℓ/min] minimum |
|
Water Pressure |
45-75psi [3-5bar] |
|
Control Voltage |
24VDC |
|
Method Programmability |
4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods |
|
Preload Pressure |
0 - 400psi [0 - 30bar] in 50psi [5bar] increments |
|
Thermoplastic Function |
Automatically sets correct parameters for thermoplastic resins such as TransOptic™ and cools the mount in a controlled, linear fashion |
|
Compliance |
In accordance with EC Directives |
